DynaVap DynaCoil

To load your DynaCoil, place a piece of concentrate on it that’s roughly the size of a grain of rice. You can use shatter, wax, rosin, or distillate. Any consistency I’ve tried on here works just fine, it’s quite versatile, which adds to the value. With a piece the size of a grain of rice you’re not going to fully vaporize it all in one draw, I just aim to vaporize as much as possible in that first draw. In general I’ve been reloading mine every time, it’s such a small amount and I want that nice fresh flavor every time, so I don’t mind reloading it. DynaVap says you can get two to six draws per load, I definitely didn’t find that I’d get six unless I really loaded a lot in there. You can get two hits per load or at the very least three hits every two loads without getting any sort of reclaim flavor.

After your DynaCoil is loaded up, put your cap on and heat the tip until it clicks, as is tradition. For dry hits, I heat closer to the end of the cap so I can get a lower temperature and really enjoy the flavor. For hits through a water piece, I heat it lower on the cap and go a second past the click to get it even hotter.

When I showed this on my Instagram profile I got a lot of questions asking “doesn’t the oil just run down into your mouth?" I can tell you that no, it does not run down into your mouth. I can only see that happening if you overload it to a comical degree or put some liquids in it. I did a total of 25 hits through a freshly cleaned unit and except for the single dry hit in the video review, every hit was done vertically with a water piece to test if it would run down the condenser. To really test it I added a half-grain size dab for every hit and did not do any second hits. After all those hits I could see down through the condenser that it was almost totally clean. No dripping, no close calls, just some mild buildup that is totally normal with regular DynaVap use. For me, this is a non-issue and something you don’t need to worry about.

Cleaning the DynaCoil is very easy. You can either pop out the coil and clean it in isopropyl alcohol or you can do what I do and just clean the whole DynaVap in iso, coil and all, then rinse well and dry in front of a fan. This takes seconds and it gets things very clean no matter which method I’ve tried.

The DynaCoil heats up like a standard DynaVap, meaning that the coil is heating up indirectly as it absorbs heat through the cap and tip itself. By the time the cap has clicked the oil is fully heated and ready to vape. However, it does not reach super high temperatures that can lead to nasty flavors or cause the oil to combust instead of vaporize. With this heating method, the vapor that you’re getting from it is very impressive. The DynaCoil adds an entirely new element to the DynaVap experience.

The taste is fantastic, it’s like having a lower-temp dab and you can definitely get terp tongue from this one. Even after 20+ hits without cleaning, you’re still getting pure and intense flavor that doesn’t taste dirty at all. The hits are super smooth even at higher temperatures, they are not harsh and don’t really make me cough. Personally though, I do prefer using the DynaCoil through water when I’m around the house.

The size of the hits are large and while I don’t find that I’m blowing out massive super-dense clouds, it doesn’t leave me wanting either. The clouds are totally satisfying and it’s pretty rare that I go back for round two right away. If you want huge hits, just heat it down low on the cap and for a second or two after the click. The effects from the DynaCoil can be very strong as well.